3451
General Mach Discussion / Re: Strage Z Touch Plate Problem
« on: November 07, 2012, 11:29:19 AM »
OK, I watched the video and have a better understanding. The DRO's counting is Mach3 doing the second probe, but for some reason you're drives aren't moving?
Also, between probes, the Z should only lift about 1/8". I have no idea why your's is lifting so high??? Is it hitting a limit switch when it goes up that high?
Do you have a Z home switch, and did you home the machine before the auto zero?
Also, between probes, the Z should only lift about 1/8". I have no idea why your's is lifting so high??? Is it hitting a limit switch when it goes up that high?
Do you have a Z home switch, and did you home the machine before the auto zero?