4351
General Mach Discussion / Re: Z-axis Auto zero wiring
« on: April 06, 2011, 10:16:36 PM »
When you touch the plate to the bit, does the digitize LED light up. It should.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
You should not be able to drive past your home switch. (shouldn't be able to drive past your limit switches either...)
Oh, another problem is that I had my X axis going the opposite as the screen was showing so I reversed the setting and now when I manually operate the tables goes the reverse way I tell it to. Everything else seems to be working OK, so far. Backlash is set, surprisingly the was none on the Z axis.