4471
General Mach Discussion / Re: DB-200S Spindle USA
« on: February 26, 2011, 08:44:52 PM »
Yes, you have to disable the built in variable speed.
It's made in Australia.
I'm using one on a Porter Cable 690.
It can overheat if you push it too hard at very low rpms. However, I've found that it runs much cooler than stock, as it uses less power under most conditions. The SuperPID only supplies enough current to maintain the rpm.
It's made in Australia.
I'm using one on a Porter Cable 690.
It can overheat if you push it too hard at very low rpms. However, I've found that it runs much cooler than stock, as it uses less power under most conditions. The SuperPID only supplies enough current to maintain the rpm.