5261
Flash Screens / Re: Tormach Flash Screen Set
« on: December 25, 2009, 03:11:12 PM »
We were supposed to get a Flash screen development manual about a year ago, but it never materialized.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
That is the question.
If your running a router at high speed yes you want the CV and the headache settings that go with it.
HelloBest performance in an inexpensive drive is the Gecko G540. $299, but it's a 4 axis drive. If you want the best bang for the least amount of money, and you don't mind soldering, look at the HobbyCNC. It's unipolar, though.
do you know of a good 3 axis controller that isn't very expensive to use?