5371
Finished Screens / Re: Mach3 Aqua
« on: October 10, 2009, 12:36:38 PM »
This doesn't work?
http://tinyurl.com/pz8az9
http://tinyurl.com/pz8az9
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
On the 'machine settings' page is it possible to get a 'goto zero' button put in?
Perhaps replace the 'G90.1' and the G91.1' buttons with 'goto zero' and 'ref all home'?
Thanks,
Timothy
On the 'run' screen why is one of the override reset buttons 'on' and the other 'off' when both are at 100%?
For some reason the backlash compensation is conflicting with my Z axis movement.
What's happening is the backlash comp is trying to move too fast, causing lost steps. What is your backlash speed % set to? try lowering it. Also try adjusting the shuttle accel setting on the general config page.