2751
General Mach Discussion / Re: Moving Mach3 license
« on: March 13, 2014, 10:29:53 PM »
It's Mach1Lic.dat
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Russ,
Yea, I thought I had it yesterday too! Nope!!!
However, I JUST GOT IT!!!!! Finally.
I had been entering the Function and F-Code first and the Execute Code line was always automatically filled with some LoadFile command. I just read your post and decided to put the HtmlDialog( GetMainFolder()+"Mach3MillGcode.htm" ) command in the Execute Code line FIRST. Then it WORKED!
Thanks!! Ya saved me from going bald(er) pulling my hair out!!
Bob