Messages

1811

General Mach Discussion / Re: Help! Dangerous Result With Mach3 And Vista Pendant

« on: August 01, 2015, 09:24:47 AM »

On Config> Toolpath, there's a checkbox to use the radius for feedrate I think.

1812

Mach4 General Discussion / Re: Mach4 and Windows 10

« on: July 31, 2015, 09:39:56 PM »

I see this as a killer for Mach on W10.

If your worried about that, just disable your network card while Mach is running.

1813

General Mach Discussion / Re: gcode issue

« on: July 31, 2015, 03:39:48 PM »

You need a Mach3 license to run all of the code.

1814

Mach4 General Discussion / Re: Mach 4 Tool Auto Zero

« on: July 28, 2015, 09:31:02 PM »

There were instructions there.
http://machremote.dyndns.org:8080/index.php?/Knowledgebase/Article/View/3/1/how-to-install-the-mach4-hobby-screen-set-with-probing

1815

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: July 28, 2015, 07:27:48 AM »

You can try using some single sided PCB material as a touch plate, as it will be isolated on one side.
Or as you said, use an actual probe.

1816

General Mach Discussion / Re: Mach 3 on Windows 10

« on: July 26, 2015, 08:00:21 PM »

If you're using the parallel port, then no, it won't work. If your using a motion controller, it should, but I don't know of anyone that's tried it yet.

1817

General Mach Discussion / Re: Pink bulls-eye overlay

« on: July 25, 2015, 06:41:34 PM »

Try changing your IJ mode to incremental.

1818

General Mach Discussion / Re: Mach 3 trial to full version

« on: July 24, 2015, 10:14:17 PM »

Nothing changes when you license the demo version. You just need to copy a license file into the Mach3 folder.

1819

General Mach Discussion / Re: Parts smaller than they should be.

« on: July 23, 2015, 11:03:41 PM »

Sorry, that was supposed to be MDI.

1820

FAQs / Re: Troubles with changing Z zero

« on: July 23, 2015, 10:32:53 PM »

But before he code is loaded I can put new tool numbers into Mach 3 and enter them and they all find the G 52 work offset zero point which confirms that the tools were measured correctly and loaded correctly into the tool table. 

It doesn't confirm anything if you're not doing it right.

Tell us exactly how your confirming that they are correct, and don't leave out any steps.