1041
General Mach Discussion / Re: Mach3, VCarve Pro, ATC router, and drag knife
« on: February 06, 2017, 05:52:23 PM »
Edit your v Carve post processor to remove the M3 that starts the spindle, and use that post for your drag knife code.
If you edit the post processor in Notepad, just remove this line:
"[N][S ]M03"
or any others with an M3 in it.
If you edit the post processor in Notepad, just remove this line:
"[N][S ]M03"
or any others with an M3 in it.