91
General Mach Discussion / Re: Z climbs during run
« on: April 29, 2019, 10:34:55 AM »Quote
and my Step pulse and Dir Pulse are at 0
If you are using the parallel port, set these to at least 2, maybe even 5.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
and my Step pulse and Dir Pulse are at 0
has anyone tried the " AXBB-E ethernet motion controller and breakout board combined controller " from the company behind of uccnc .
'Note that there are also, FRENCH and ITALIAN probing macros (posted in this forum) that DO NOT use those legacy setvar() and getvar() functions.
But that is what the SLOW ZONE column is for.
In my case, I set it to SLOW DOWN when 20mm from the switches (see attached).
This only works if you ALSO set soft limits from 0 to say 1mm from the far end limit switch and the SOFTLIMITS is also on during program run.
1.Set the probe user dro 2000,2001,2002 to replace the variable 2000,2001,2002.
so user could getuserdro(2000) to replace the GetVar(2000) when probing.