111
General Mach Discussion / Re: StepCraft inlcuding a WinPC-NC USB-Module
« on: April 16, 2019, 08:46:00 PM »
In your pics, the USB version is the WinPC-NC board. The parallel version is for plugging a UC100 into.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Why not try the plugin for UC100.
You might have a rebadged UC100 since in Australia stepcraft 2/840 comes bundled with a UC100 from CNCDRIVE.
Hi Russ,
on other forums a new members first post must be approved by a moderator before its posted.
Does your model support the use of a "BRAKING RESISTOR" to stop the spindle in less than 1 sec?