4461
General Mach Discussion / Re: Cuts much too large
« on: March 02, 2011, 05:02:21 PM »
Sounds like your setup in metric, and the g-code is inches? Or the opposite?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thanks for the ideas guys.
First I will try out Kerry Harrisons program and if that does not work I will reinstall XP and go through the optimization page.
I have two questions though, when installing XP should I upgrade to service pack 2 or just leave it as service pack 1. Also should I go out and install all the device drivers on the machine or just the ones that are required for running the cnc machine?