751
General Mach Discussion / Re: CNC Router "Stutters/Loses Position" on Faster Feed Rates
« on: November 28, 2017, 10:19:48 PM »
If your drive is set to 400 steps/rev, that would mean your screws have a 1 mm pitch.
Does the machine move the correct distance?
With 1mm pitch screws, 30ipm would be about 750 rpm, which you'd be unlikely to get with only 24V.
Also, you shouldn't have it set to 4 amps with a 2.8amp motor, as it'll damage the motor.
Does the machine move the correct distance?
With 1mm pitch screws, 30ipm would be about 750 rpm, which you'd be unlikely to get with only 24V.
Also, you shouldn't have it set to 4 amps with a 2.8amp motor, as it'll damage the motor.