661
General Mach Discussion / Re: Cut not going into corners?
« on: January 25, 2018, 11:43:06 AM »
Try setting "Stop CV on Angles<" to 89 in General Config.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Lets calculate the requirements for hobbylevel close loop with common steppers:
I thought CNC Drive had released a Mach4 plug-in that was supposed to support
threading, but I can find no mention of threading on their web site nor have
there been any forum mentions from users.
Please do not make me watch a Video or read a webpage when in 30 seconds I can find my answer in the PDF.