3651
Tangent Corner / Re: Sanyo Denki Stepper ?'s
« on: May 06, 2012, 12:24:15 PM »
The Gecko's dictate the current, not the motor. Set the Geckos for 7 amps and your good, but you'll lose about 25% of the rated torque (7÷9).
Larken makes a 10 amp drive. http://www.larkencnc.com/motion/steppers.htm
Larken makes a 10 amp drive. http://www.larkencnc.com/motion/steppers.htm