6111
Forum suggestions and report forum problems. / Re: Popup???
« on: November 16, 2006, 09:25:11 AM »
Yep, that's it. Very strange that today I started dragging my mouse all over you, but never before??
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
The standard is to run the feed rate up slowly until you break the bit. Back off 10% and that is optimal.
DeskEngraver seems to come close but it does not produce a DXF that AutoCAD 2005 can read (reports a file configuration error).