Messages

1

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: March 23, 2023, 09:12:25 PM »

If it continues, then that usually means the macro finished, which means it triggered twice. When noise triggers the input, it usually happens so fast you don't see it.

2

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: March 23, 2023, 07:14:41 PM »

When it probes it one time, is it finished, or is there an error message? If it's finished, then your probe input is probably triggering twice due to noise.

3

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: May 22, 2022, 12:43:10 PM »

I would add some small invisible (transparent) buttons somewhere on the screen where no you normally wouldn't click them, and add shortcuts to the buttons.

4

General Mach Discussion / Re: GetVar(2002) Incorrect values returned

« on: October 01, 2021, 07:48:11 PM »

Did anything change in your system?
Are you using a motion controller? If so, which one. Many do not support GetVar() properly.
If nothing has changed, try replacing your .xml file with a backup.

5

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: May 10, 2021, 05:09:28 PM »

That is how it is supposed to work, with all of them the same. So that if you change offsets, your Z zero stays the same.

6

General Mach Discussion / Re: Mach3

« on: May 09, 2021, 06:04:40 AM »

So you don’t enter any settings for the port number if it’s usb?  The driver takes care of the address?  Cheers Iain

No, no port address needed with a USB controller.

7

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: May 09, 2021, 05:57:19 AM »

Try modifying those macros be replacing any instance of GetVar(2002) with GetOEMDro(802).
They should work after that.
They do use GetVar and SetVAr to write the other offsets, but I think that Getvar is only an issue with probing with those controllers.

8

G-Code, CAD, and CAM discussions / Re: UC100 G02 will not work

« on: February 26, 2021, 08:01:41 PM »

As posted above, thousands of people have been using the UC100 for over a decade, and the only time I've ever heard of this is in this thread.

9

Mach Screens / Re: OEM button code

« on: January 30, 2021, 02:37:03 PM »

The USB Controller you are using may not support the Offline function. Especially if it's Chinese.

10

General Mach Discussion / Re: Years on now Mach 3 is dropping out on me? Screenset 2010

« on: October 27, 2020, 07:39:50 PM »

Unfortunately, I've never heard of this happening, and I can't reproduce it.
I'd try creating a new profile, and setting it up from scratch.