1571
General Mach Discussion / Re: Issue with X & Y
« on: December 23, 2015, 05:50:48 PM »
If you want to operate the machine the way you show in the video, then you should swap the X and Y axis on your machine.
You can not change the orientation of the axis in the toolpath display.
X is always left to right.
Y is always front to back.
By changing the hotkeys from the defaults, you made is so your arrow keys don't match what you see in the toolpath display.
Your options are to either swap the X and Y axis, or operate the machine from the side, where it will match the toolpath display.
You can not change the orientation of the axis in the toolpath display.
X is always left to right.
Y is always front to back.
By changing the hotkeys from the defaults, you made is so your arrow keys don't match what you see in the toolpath display.
Your options are to either swap the X and Y axis, or operate the machine from the side, where it will match the toolpath display.