Messages

671

General Mach Discussion / Re: Using external inputs and OEM codes

« on: June 05, 2004, 04:55:15 AM »

Hi, Cnceer

Looking at PM you sent me.

Is it a Script issue ?

If your trying to Zero the Z axis Dro with a external  button,

Hears two screen shots that should help,

Set for pin 10, trigger 1, Gnd pin 10 to Zero Z (OEM 1010).

Hope this Helps, Chip

672

General Mach Discussion / Re: Mach2 V. mach3 help

« on: October 11, 2008, 11:45:23 PM »

Hi, Gage

Double check your Motor Outputs page settings, Pin assignments will be different though.

If I remember the Active Low settings may be different in Mach3 than Mach2.

Hope this Helps, Chip

673

G-Code, CAD, and CAM discussions / Re: Slow step in G19 G2 move

« on: October 06, 2008, 02:19:37 AM »

Hi, Bill

Ran your G-code with Mach3 ver. 3.042.012, didn't notice any delays.

What version are you using ?

Chip

674

LazyCam (Beta) / Re: Rev. Numbers

« on: September 10, 2008, 02:29:15 PM »

Hi, Brian

Would you post your DXF, There are import  Connection Line Tol. on the Setup, Loading Options page, Dxf differ allot, Try .1, .01 & .001.

.! may help to connect them togeather

Thanks, Chip

675

General Mach Discussion / Re: Problems in Setting up 4th axis!!!

« on: September 09, 2008, 11:59:36 PM »

Hi, Khalid

1., 2. Looks to me the Z0 should be set to top right of your work, X, Y right end above A axis CL (G Code you posted).

3. Most likely right end x,y,z center point Post the G Code for it.

4. In 4th axis there is no green last to current just the cross hairs.

Your 4th (A) axis Steps Per need to be 4.2855555 for 1 deg movement, 1548.2/360= 4.2855555.

Chip

676

General Mach Discussion / Re: Problems in Setting up 4th axis!!!

« on: September 08, 2008, 06:11:39 PM »

Hi, Khalid

The A axis Dia". on Settings Page is used to keep the cut speeds and display view proper for the part Dia.

Both methods should work fine, It just depends where you want to start your Z position from.

If I missed your point let me now, Chip

677

General Mach Discussion / Re: Problems in Setting up 4th axis!!!

« on: September 07, 2008, 02:45:56 PM »

Hi, Khalid

You need to set "A axis Dia". on Settings Page, 7 inches looks fairly close.

Chip

678

General Mach Discussion / Re: How do I remove this out of the gcode

« on: August 26, 2008, 01:41:52 AM »

Hi, David

The G-code that's produced are single circle's, Is this creating an Issue ?

Chip

679

General Mach Discussion / Re: How do I remove this out of the gcode

« on: August 25, 2008, 10:48:19 PM »

Hi, David

I don't see the problem hear with your LCAM file, Post the dxf.

Chip

680

General Mach Discussion / Re: How do I remove this out of the gcode

« on: August 25, 2008, 09:49:03 PM »

Hi, David

Any Time, Chip