Hello Guest it is March 28, 2024, 04:36:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chip

541
LazyTurn / Re: LazyTurn
« on: December 27, 2008, 10:57:35 PM »
Hi Dennis

Try this one with a .48 per pass value rough and LCam Turn final pass.

Chip

542
Hi, Scrappy

Have a servo driven small robotic arm I'm converting to step & direction and Mach3, Did you get your View screen situation worked out.

Chip

543
LazyTurn / Re: LazyTurn
« on: December 27, 2008, 10:05:22 PM »
Hi, Art, Dennis

It looks as if it's not liking the 0.5 value.
Hears a test dxf and some pic's and a tap file.

Chip

Edit: .49 drop's a pass left side at Arrow, .48 pick's it back up, Both sides of the part are the same dia. "10" unit's from X zero. ?

544
Show"N"Tell ( Your Machines) / Re: My new project
« on: December 27, 2008, 03:03:57 PM »
Hi, Monty

Making a new disk is the way to go as suggested above.

On my Emco Comp. 5 lathe, I used the existing OPTO sensor/pickup, Only needed to add a current limiting resistor to power the OPTO sensor properly.

Original Disk was about 5 inch in dia., With the single slot width being about a 1/4 inch, Increased it to 7/8 inch and It's good to 4000 rpm.

Mach3 just need's additional time/width to see the change of State of the OPTO sensor at your max spindle speed.

Nice looking Lathe, You haft'a do what you haft'a do to u-load these machine's.

Hope this Helps, Chip

545
LazyTurn / Re: LazyTurn
« on: December 26, 2008, 11:01:40 PM »
Hi, All

Using SP2 hear, Seems fine.

Dennis, Hears a cut file for your dxf,

Chip 

546
General Mach Discussion / Re: Help eliminate toolpath
« on: December 26, 2008, 01:05:00 AM »
Hi, Scrappy

Dose turning off the Tool-Path on the Diagnostics Page help.

Chip

547
LazyTurn / Re: LazyTurn
« on: December 25, 2008, 11:04:55 PM »
Hi, Art & All

Latest 25-4 seems to work hear also, U-Ho-Ho-Ho-Ho, Thanks Art.

Back to Testing, Now where was I testing ?

Thanks, Chip  :D

548
General Mach Discussion / Re: New Cutter Comp code and Examples
« on: December 25, 2008, 03:39:51 PM »
HO HO HO,

Is this "Let The Games Begin", Good, Needed a De-Version, Look Honey, A new version of Mach3 for X-Mass's.

Thanks, Chip

549
LazyTurn / Re: LazyTurn
« on: December 25, 2008, 02:32:52 PM »
Hi, RC

Your dxf works on ver prior to 12 23 08, But I get a 406 error on latest version no mater what the Accl. values are set to.

Thanks, Chip

550
LazyTurn / Re: LazyTurn
« on: December 25, 2008, 01:48:12 PM »
Hi, RC

Doesn't seem to help hear, My BobCad v23 won't tolerate a setting above 2 clicks from None on the Acceleration.

Thanks, Chip