Guest
Show Posts
1471
LazyCam (Beta) / Re: LazyCam 2.081 Issues
« on: July 08, 2007, 12:50:17 AM »
Hi, Art
1. The red line Chain#0 shows 2 line segments and 1 arc., Should be 3 individual Chains, Really messes up the way you want to cut.
Art: {If lines are joined, they become a chain, no way out of that at the moment.}
The lines arn't joined there all the same, Why not all ? Ref. the DXF
2. The second picture shows trying to move start point for one of the arc's, Turns into Circle, Will go away now when moved back.
{ Looks like a bug.. but moving a start point of an arc can be hard if you dont move end and center. I dont think you can do that yet. It shoudl be drawn in the right spot.}
Just trying to move the start point to other end of Arc., All the arc's are correct, Just pointing out the full circle if you go past end point.
3. Loaded file always has a rapid hight, Sometimes it's 0, 1 or 60 in Max Z Chain's Tab, Even if all Tabs show 0 for Z , The View shows some Rapid Hight when loaded.
{ Loaded files get set to defaults, all default have a rapid, you have to manually change them}
When you load a 2D drawing it has 0 hight, View shows hight, All Tab's Z's show 0 even Layer Tab, Until you select a layer, Just strange some times it's 60.
OooWell'
4. Where do you change the Drill peck distance, Only peck's first hole down to Z 0 then no peck to final depth..
{There is no peck cycle in Lazycam as yet. It only drills..}
First drill point rapids up after reaching 0, The rest just drill, Just pointing it out. OK
5. Save as Shape File isn't working hear, File Open Failed Error.
Thanks for looking, Chip
1. The red line Chain#0 shows 2 line segments and 1 arc., Should be 3 individual Chains, Really messes up the way you want to cut.
Art: {If lines are joined, they become a chain, no way out of that at the moment.}
The lines arn't joined there all the same, Why not all ? Ref. the DXF
2. The second picture shows trying to move start point for one of the arc's, Turns into Circle, Will go away now when moved back.
{ Looks like a bug.. but moving a start point of an arc can be hard if you dont move end and center. I dont think you can do that yet. It shoudl be drawn in the right spot.}
Just trying to move the start point to other end of Arc., All the arc's are correct, Just pointing out the full circle if you go past end point.
3. Loaded file always has a rapid hight, Sometimes it's 0, 1 or 60 in Max Z Chain's Tab, Even if all Tabs show 0 for Z , The View shows some Rapid Hight when loaded.
{ Loaded files get set to defaults, all default have a rapid, you have to manually change them}
When you load a 2D drawing it has 0 hight, View shows hight, All Tab's Z's show 0 even Layer Tab, Until you select a layer, Just strange some times it's 60.
OooWell'
4. Where do you change the Drill peck distance, Only peck's first hole down to Z 0 then no peck to final depth..
{There is no peck cycle in Lazycam as yet. It only drills..}
First drill point rapids up after reaching 0, The rest just drill, Just pointing it out. OK
5. Save as Shape File isn't working hear, File Open Failed Error.
Thanks for looking, Chip