Messages

51

General Mach Discussion / Re: Help wih Mach 3 Download

« on: September 11, 2009, 10:08:04 PM »

Hi, Rusty 

Yes, That's what I do.

Chip

52

General Mach Discussion / Re: MACH 3 SUPPORT

« on: September 11, 2009, 08:38:47 PM »

Hi, BORDER PATROL

It appears that you have 8 wire steppers to me, If your driver is bipolar then ref to the attached pdf for 8 wire connection options.

If your driver is uni-pole then there is only one way to wire the steppers.

Lit us know as Hood stated.

Chip

53

General Mach Discussion / Re: Problems with Y-axis

« on: September 10, 2009, 10:25:57 PM »

Hi, Steven

Not sure of the issues with the arrow key's, But glad you got it sorted out.

Chip

54

General Mach Discussion / Re: Problems with Y-axis

« on: September 10, 2009, 01:25:01 PM »

Hi, Steven

Tried your xml file, It has issues, Try this one should work, It's got most of your settings in it.

Chip

55

G-Code, CAD, and CAM discussions / Re: Chains and entities question

« on: September 03, 2009, 10:56:01 PM »

Hi, Steve

I used Bill's LCam file and used the .250 cutter for the tool, Are you using the Great Island's option as in pic 1 also selecting the chaines as in pic 2.

Hears a LCam file too look at, You will need to setup all the depths of cuts and move Chines around also.

Chip

56

G-Code, CAD, and CAM discussions / Re: Chains and entities question

« on: September 01, 2009, 11:05:25 PM »

Hi, Steve

Post your dxf as "TP" stated, You can also try changing the Setup, "Load Options" as shone in pic below,Then re-load the dxf and re-pocket it.

Chip

57

G-Code, CAD, and CAM discussions / Re: g-code newbee questions

« on: September 01, 2009, 05:40:42 PM »

Hi, Carl

Mach3 can load 4 different type of file extensions, TAP, NC, TXT, NCC, These are common extensions used by various programs for G code format's and other programs for there own special use.

Hope this helps, Chip

58

LazyCam (Beta) / Re: Problem generating g-code

« on: September 01, 2009, 04:34:58 PM »

Hi, Dennis

Hears the LCam3.00.2.exe

Chip

59

General Mach Discussion / Re: Cut is off to one side

« on: August 27, 2009, 05:07:01 PM »

Hi, Dave

Glad you got it sorted out.

Chip

60

General Mach Discussion / Re: 555 Timer index pulse widening

« on: August 25, 2009, 07:09:08 PM »

Hears the pic I've been trying to attach.

Chip