1881
General Mach Discussion / Re: Ratary axix, works in Mach2 but wont in Mach3
« on: November 06, 2006, 11:25:02 AM »
Hi, Konstantin
Try setting A axis Step Low Active to Checked, Some stepper cont, card's are sensitive to leading-trailing edge state change, Config, Port's pin's Motor Outputs.
Try this out, Chip
Try setting A axis Step Low Active to Checked, Some stepper cont, card's are sensitive to leading-trailing edge state change, Config, Port's pin's Motor Outputs.
Try this out, Chip