41
FAQs / Re: Set up G-code step unit question. (Newbie)
« on: October 25, 2009, 03:08:44 PM »
Hi, Mike
Sounds like your machine is not setup or calibrated properly, Under Config, "Set Default Units" to Inch mode then you need to re-do your Steps Per and re-tune Velocity and Acceleration in Config, Motor Tuning.
Hope this helps, Chip
Sounds like your machine is not setup or calibrated properly, Under Config, "Set Default Units" to Inch mode then you need to re-do your Steps Per and re-tune Velocity and Acceleration in Config, Motor Tuning.
Hope this helps, Chip