Hello Guest it is March 28, 2024, 12:37:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chip

31
General Mach Discussion / Re: dwell for the spindle
« on: November 13, 2009, 05:53:38 PM »
Hi, Bryson

Make sure your settings in Config, Ports & Pins, Spindle Setup, "CW Delay spin-Down are set to Zero.

Chip

32
LazyCam (Beta) / Re: How can I make the zero in lazy Cam
« on: November 12, 2009, 11:34:36 AM »

33
General Mach Discussion / Re: Sherline cnc rotary table
« on: November 10, 2009, 08:27:58 PM »
Hi, Fastest1

Are you entering a Value in Settings Page ? and using G01 with F "feed speed" set to a value ?.

Chip

34
General Mach Discussion / Re: nedd program help
« on: November 09, 2009, 01:21:38 PM »
Hi, Krymis

In General Config, Check your IJ settings, Loads fine hear.

Chip

35
General Mach Discussion / Re: New REV
« on: November 09, 2009, 01:11:13 PM »
Hi, All

New revision under Downloads above.

Chip

36
General Mach Discussion / Re: Bridgeport conversion help
« on: November 08, 2009, 10:11:19 AM »
Hi, Nick

Each axis is controlled by what I call rollover or Max CL mode in Mach3,  Sent you a PM message.

Chip

37
General Mach Discussion / Re: Bridgeport conversion help
« on: November 07, 2009, 05:05:50 PM »
Hi Nick

Theirs a 6 pin connector Blue wires on the back of the second cpu board, Use the 6 wires and a common GND.and set Mach to Max CL mode.

Chip

38
LazyCam (Beta) / Re: problem with lazycam
« on: November 02, 2009, 07:34:54 PM »
Hi, Edmund

Sure, Give me a call.

Chip

39
Hi, Rich

You'll probably find that your Arc's are really short line segment's, The only way to deal with it is to find a cad program that generates the arc's as curves so you'll get G02 and G03's, This has always been an Issue, It's been discussed allot and at the moment I don't have any good recommendation's for a cad program.

Chip

40
Hi, Rich

G64 Constant Velocity Mode will give you this problem, Use G61 Exact Stop Mode when you want sharp corners.

Chip