Messages

2051

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: May 02, 2006, 10:15:58 AM »

Hi, Brian

If I load this file with lazycam in default as drawn with no leadin's on, then try to set the leadin at the bottom left 0,0 / target, it error's out and want's to send an error code to microsoft, also if I try to set a inside cir. leadin  on the triangle, far right side it's on the outside and if you set an outside it's on the inside, just backward's.

Just some problem's to look at.

Thank's Chip

2052

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: May 02, 2006, 01:05:01 AM »

Hi, Brian

Thank's for the fast reply, It's not just the layer's in my post, but that's ok, I now you guy's are swamped with issue's.

I'll re-post them in a few day's

Thank's Chip

2053

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: May 01, 2006, 02:20:34 PM »

Hi, Brian

Have you had a chance to look at this problem.

Thank's Chip

2054

LazyCam (Beta) / Re: LAZYCAM Layer control

« on: April 20, 2006, 12:30:27 AM »

Hi, Brian

The file i sent you will show three layer's when imported back into turbocad and rino.

Thank's Chip

2055

LazyCam (Beta) / LAZYCAM Layer control

« on: April 19, 2006, 03:53:28 PM »

Hi, Art and Brian

I have been working with lazycam it's really nice I don't now what
functions are implemented at this point. Using Mach3D1.90.028

I have uploaded a file in Lazycam folder test55.dxf a turbocad ver. 8
some time ago never got a responce.

It's a 3 layer dxf one object per layer, hear is what i find.

While layer control shows 3 layer's only layer 0 has objects.

If I click on 0,0 Target, program end's with prompt to send error
report. This is the start point for first object on layer 0, can't set
leadin.

Also if you highlight the first object to move the leadin and click the leadin location the same thing happen's.

I've included an attachment of the file hear


Thank's Chip

2056

Works in progress / Re: New Screen released ( Beta 1)

« on: April 11, 2006, 12:31:35 PM »

Hi, Benny

Downloaded your screen.set really nice.

I see your having problems as I was with the double click to straight view it only work's on your Diag. screen..

I fixed mine by using Scree4 and Copy/Past the  good View/cut  screen (Diag.) and replaced the ones generated with Screen4.

There is still a problem with safe Z level red dashed line's getting behind the cut view must be a code error.

Thank's Chip