Hello Guest it is March 28, 2024, 12:24:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chip

1691
Hi, swarf_rat & Hood

Hit the Tab Key find Mpg axis, 2nd axis, 3rd axis, I've tested 2 out of 3, Bet thy all work,

Go get um, Chip

1692
G-Code, CAD, and CAM discussions / Re: Leaving a tab on cut out parts
« on: February 25, 2007, 11:29:00 PM »
Hi, Sparky

Generate the tabs in your Cad, wont that get you there.

Gust a Thought, Chip

1693
General Mach Discussion / Re: Wild Rotory
« on: February 25, 2007, 11:20:17 PM »
Hi, Escowizard

If you Hit "Ref All" and it Homes in the Wrong Direction, under Config, Home Limits Page, you can change the Direction, click on Home Neg Box for that axis.

It may work on your 400 Mhz machine being it prob. cuts slower any way cutting profiles, Get it working good at home first.

New you'd Like It, Chip

1694
LazyCam (Beta) / Re: Tool offset problems
« on: February 25, 2007, 05:34:51 PM »
Hi, Psad

You also need to turn "Leadin on"  on each line segment, click on line, double click on start point, window opens to set it?

Probably now this, just didn't mention it in your post.

Hope this Helps, Chip

1695
Hi, Paul

Sent you a Personal Message, its at the very top of this screen

Thanks, Chip

1696
General Mach Discussion / Re: Dear God What have I done
« on: February 24, 2007, 09:12:49 PM »
Hi, Bathgate

Hear you go a 1024.set file, load  into your Mach3 folder, named just for you.

Make a copy of it then rename it 1024 your bak in bizzness.

Hope this Helps, Chip

1697
Hi, ToadSprockett

Looked at your XML file, Changed the Ports/Pins X Inputs to Check mark's, If I remember right pin 11 is active High rev logic from pin 12.

Give this XML a try, jog out away from your table limit's ref Home, manually click the switches.

Hope this gets it, Chip

1698
General Mach Discussion / Re: Wild Rotory
« on: February 23, 2007, 09:38:02 PM »
Hi, Escowizard

Yes same license, Got it all figured out yet.?

Have Fun, Chip

1699
General Mach Discussion / Re: Help Define
« on: February 23, 2007, 09:31:39 PM »
Hi, Charlie

There is a Mach3 manual that explains all of this, above, Tutorials, Documentations.

This will take you there, http://www.machsupport.com/documentation/M3M1_84-A2.pdf

Hope this Helps, Chip

1700
Hi, David

Your servo control uses the encoder to stay on track and bootstrap encoder info to the +-10 volt to step and dir cards, which interface to Mach3. Realy hard to say without the wiring Diag's Though.

I did a conversion, simmilar to yours on a Waterjet Cutter 4 axis, works Great.

Dig out the Manual's out of storage your going to need them

On the Ball-screws if you can get to one of them X or y turn it one turn measure table movement, are your servos direct-connect to ball-screws. Look's like you can turn the Y axis on front of Mill.

Where do you live?

Thanks, Chip