Messages

981

LazyCam (Beta) / Re: LazyCam 3.00.1 from ftp site, can't install

« on: March 17, 2008, 03:09:09 AM »

Hi, Monte

Hears a link  to ver 3.00.2, Give it a try, Towards the bottom, Or re-download the other one and try again.

http://www.machsupport.com/artsoft/downloads/downloads.htm

Thanks, Chip

982

General Mach Discussion / Re: Mach 3 Failed?

« on: March 17, 2008, 01:51:54 AM »

Hi, Mike

Under Config, Homes & Llimits, There is a "Reversed" coll-um, Change the Z "X" mark to "Checked", That should do it.

Thanks, Chip

983

Works in progress / Wide Screen

« on: March 17, 2008, 12:50:40 AM »

Hi, Terry

It can be done, Need to load mach3, Then reload this screen after you expand Mach across both monitors.

Expand Screen4 across both monitors also when editing..

Thanks, Chip

984

LazyCam (Beta) / Re: hold tabs and slots

« on: March 16, 2008, 10:51:54 PM »

Hi, Jim

Using LC3.00.2 hear, Two chaines two different Tabs set.

Do your tool & off-setting and deleting first, Then set set your Z-levels on remaining layers.

Post your dxf will look at it, REPLY, Additional Options.

Hope this Helps, Chip

985

General Mach Discussion / Mach3R3.037 & Reff All Home inop error Msgs.

« on: March 16, 2008, 04:16:11 AM »

Hi, Brian

Reff All Home not working error Msg. today.

Thanks, Chip

986

General Mach Discussion / Re: Problem on opening Mach 3

« on: March 15, 2008, 12:19:50 PM »

Hi, Hunnam

If your DRO's aren't moving, Then it must be some other program in the background on your computer.

Did you Re-Boot your computer after installing Mach3 ?

Run the Driver Test, It's in C:\mach3\  folder.

Re-Install Mach3.

May need to referr to the Optimization Doc. hear  http://www.machsupport.com/optimisation%20XP.txt

Thanks, Chip

987

G-Code, CAD, and CAM discussions / Re: 3D Basic Design Help Will Pay $$$ EnRoute

« on: March 15, 2008, 12:39:52 AM »

Hi, Dustyn

Hears a shot.

Chip

988

G-Code, CAD, and CAM discussions / Re: Mach and Bobcad Version 19

« on: March 14, 2008, 05:16:05 PM »

Hi, Mike

I have ver 22 hear, I understand the, "salesmen and now their driving me crazy trying to tell me to move to version 22" issues.

Tell us about the, "simple round little cutter" and "I would really like to see if I could make this little tool".

Thanks, Chip

989

LazyCam (Beta) / Re: Lazycam project X-Y size diffrent from DFX file X_Ysize

« on: March 14, 2008, 02:10:23 AM »

Mike
use ver. 12

Chip

990

G-Code, CAD, and CAM discussions / Re: 3D Basic Design Help Will Pay $$$ EnRoute

« on: March 14, 2008, 12:41:18 AM »

Hi, Dustyn

Dose your machine use Mach3 for it's control, What size rectangles and depth of cut, Cutter size, Outside or inside cut's ?

Thanks, Chip