971
General Mach Discussion / Re: missing steps???!
« on: March 18, 2008, 04:20:54 PM »
Hi, Bill
Reduce the Velocity and Acceleration some for the X axis, Velocity is used as your top Feed-rate Rapid G00 moves.
Have you checked the Gecko's manual for jumpers and adjustment's for large steppers.
Hope this Helps, Chip
Reduce the Velocity and Acceleration some for the X axis, Velocity is used as your top Feed-rate Rapid G00 moves.
Have you checked the Gecko's manual for jumpers and adjustment's for large steppers.
Hope this Helps, Chip