14721
General Mach Discussion / Re: CamBam Gcode problems
« on: September 15, 2010, 06:09:51 PM »
I am probably not the best to describe exactly what it does as I dont really know myself
Basically though it is either Absolute or Incremental, for example if you were at X50 and commanded a move of X2 when in absolute it would move to X2, if you were in incremental mode it would move to X52 as it is incrementing by the value you commanded. The IJ mode is for arcs so it would be the same idea with Absolute or Incremental but just on an arc.
Hood
Basically though it is either Absolute or Incremental, for example if you were at X50 and commanded a move of X2 when in absolute it would move to X2, if you were in incremental mode it would move to X52 as it is incrementing by the value you commanded. The IJ mode is for arcs so it would be the same idea with Absolute or Incremental but just on an arc.
Hood