6541
CS-Lab / Re: First impressions of CS-Lab products
« on: December 22, 2012, 12:20:15 PM »
Dan
Here is a vid I took this afternoon of the Conect threading 25mm Dia mild steel and 2mm pitch, as you can see the pull out is instant. http://youtu.be/8c1sndp-554
Below is a pic of the thread.
Regards the selection of jogging, I had a thought last night and tried it out this afternoon. The rotary switch I am using for axis selection has 12 positions but I had the lock tab so only 2 could be selected (X and Z)I moved the tab round one position so I now have 3 positions on the switch, the last not being connected to anything thus it effectively cuts the power to the X and Y axis select inputs. When I chose that position I was then able to select the Jog mode and use the keyboard to jog.
Hood
Here is a vid I took this afternoon of the Conect threading 25mm Dia mild steel and 2mm pitch, as you can see the pull out is instant. http://youtu.be/8c1sndp-554
Below is a pic of the thread.
Regards the selection of jogging, I had a thought last night and tried it out this afternoon. The rotary switch I am using for axis selection has 12 positions but I had the lock tab so only 2 could be selected (X and Z)I moved the tab round one position so I now have 3 positions on the switch, the last not being connected to anything thus it effectively cuts the power to the X and Y axis select inputs. When I chose that position I was then able to select the Jog mode and use the keyboard to jog.
Hood