17961
General Mach Discussion / Re: Can I use Suqiang SN2000 Serial Servo motor drive with Mach3
« on: September 16, 2009, 04:52:51 AM »
Open notepad and type
DoButton( 24 )
DoButton( 23 )
DoButton( 22 )
DoButton( 25 )
Then save it as m101.m1s in the macro folder of the profile you use, for example if you use the default Mach3Mill profile you save to C:\Mach3\Macros\Mach3Mill
Then put m101 in the initialisation string.
You dont have to save it as m101, you can save it as any m number you like as long as its above 100 and it is not being used already by another custom macro.
Hood
DoButton( 24 )
DoButton( 23 )
DoButton( 22 )
DoButton( 25 )
Then save it as m101.m1s in the macro folder of the profile you use, for example if you use the default Mach3Mill profile you save to C:\Mach3\Macros\Mach3Mill
Then put m101 in the initialisation string.
You dont have to save it as m101, you can save it as any m number you like as long as its above 100 and it is not being used already by another custom macro.
Hood