23091
General Mach Discussion / Re: convert Plasmacam's *.pcm to mach3 *.tap file
« on: June 01, 2008, 03:48:03 AM »
Sorry dont use LazyCAM so cant say where you will set the Z height but it has to be there somewhere.
Had a look at the pcm and have done a lot of google searches but come up a blank with that as well
Is the pcm you have attached the actual code that the plasma runs from or is it some form of drawing file?
Hood
Had a look at the pcm and have done a lot of google searches but come up a blank with that as well
Is the pcm you have attached the actual code that the plasma runs from or is it some form of drawing file?
Hood