12841
General Mach Discussion / Re: Mach3Turn Offsets?
« on: February 08, 2011, 10:18:12 AM »
I couldnt understand either why Gang tooling would not work with the tool table offsets but good you got it working as its really simple to set up and keep track of.
Regards the peck in the last PP, it should rapid back in, can you attach your .cnc again so I can figure out where its going wrong for you.
Hood
Regards the peck in the last PP, it should rapid back in, can you attach your .cnc again so I can figure out where its going wrong for you.
Hood