5971
Show"N"Tell ( Your Machines) / Re: Chiron FZ12 on its way sometime soon(ish)
« on: February 15, 2013, 02:55:50 PM »
Dan,
the toolsetter on the Beaver Mill is very convenient indeed and I knew I just had to make one for the Chiron.
Regarding the drives, just keep an eye out on eBay, guy had the motor and drive listed seperately, £150 motor £250 drive and said he had more. emailed him to ask how many he had and how much he would be for multiples, he came back wit a price and I asked if he could do a bit better and he did
Brett
Doesnt take minutes to do that, bore and tap 12 holes , will take a bit longer to run the wires and get them all wired. Spent a while the last night soldering 132wires into the D Sub connectors on the I/O cable, now have to cut them off as these drives are different
Hood
the toolsetter on the Beaver Mill is very convenient indeed and I knew I just had to make one for the Chiron.
Regarding the drives, just keep an eye out on eBay, guy had the motor and drive listed seperately, £150 motor £250 drive and said he had more. emailed him to ask how many he had and how much he would be for multiples, he came back wit a price and I asked if he could do a bit better and he did
Brett
Doesnt take minutes to do that, bore and tap 12 holes , will take a bit longer to run the wires and get them all wired. Spent a while the last night soldering 132wires into the D Sub connectors on the I/O cable, now have to cut them off as these drives are different
Hood