18581
General Mach Discussion / Re: Thread milling using Mach3 centering single point threading tool question
« on: July 17, 2009, 04:25:38 PM »
I would think it be the centre of the cutter that you want but not too sure I am really understanding what you mean.
Dont think the wizard will do code for taper threads.
Yes any threadform can be done as long as you have the correct tool, the problem may be rigidity in threads such as acme.
Hood
Dont think the wizard will do code for taper threads.
Yes any threadform can be done as long as you have the correct tool, the problem may be rigidity in threads such as acme.
Hood