23881
General Mach Discussion / Re: Problem zeroing to part
« on: January 20, 2008, 12:26:13 PM »
You are zeroing correctly, your cutter centre is where you want the 0,0 position of your partto be. If you zero off a bit all that will happen is Mach will start cutting off that amount and if your stock is tight on size you will miss it. Dont think there is anything wrong with your motors or tuning as you say parts come out right.
Have you actually jogged from the 0 0 point to the toolpath and looked in Machs DROs to see how far its travelled?
To attach your code you can go to the full reply form and using the additional options button.
Hood
Have you actually jogged from the 0 0 point to the toolpath and looked in Machs DROs to see how far its travelled?
To attach your code you can go to the full reply form and using the additional options button.
Hood