9871
General Mach Discussion / Re: re : Mach turn ,tool radius index too big
« on: December 29, 2011, 04:52:02 PM »
Seems to be fine, loaded some code of my own and all is well. Just need to get your BobCAD post sorted and you will be on the way
The G76 BobCAD is putting out is all wrong, heres and example of the code in my G76
G76 X10.25 Z-10.5 I29.0 P1.75 H0.2 Q02 T0 C1.2
Mine is metric so numbers may look funny
If you use the simple threading wizard you should get code that will run well enough for you.
Hood
The G76 BobCAD is putting out is all wrong, heres and example of the code in my G76
G76 X10.25 Z-10.5 I29.0 P1.75 H0.2 Q02 T0 C1.2
Mine is metric so numbers may look funny
If you use the simple threading wizard you should get code that will run well enough for you.
Hood