20271
General Mach Discussion / Re: Spindle turns with any Z move?
« on: January 31, 2009, 06:11:33 PM »
So from your setup basically all you are doing is supplying a pulse from pin 16 and that gets converted to a 0 to 10v in the digispeed? Sorry never used one
If that is the case then sounds like your Z axis is inducing noise in the spindle wire which in turn is making the digispeed send out a voltage. Maybe try some shielded wire from the Bob to the digispeed.
Hood
If that is the case then sounds like your Z axis is inducing noise in the spindle wire which in turn is making the digispeed send out a voltage. Maybe try some shielded wire from the Bob to the digispeed.
Hood