21111
General Mach Discussion / Re: Quastion about 2 motors on one ax and correcting by encoders
« on: November 15, 2008, 11:44:33 AM »
It is the servo drive that needs to accept Step/Dir rather than the motor, there are many drives that do that but you will have to be more specific about your needs before anyone can advise what you need. As an example I need large servos for my machine and I have used Allen Bradley and Giddings and Lewis AC servos and drives. If you dont require such large motors then you can look at the Geckos, Rutex, Granite Devices, Tek10's, Vipers etc.
Hood
Hood