17731
General Mach Discussion / Re: Lathe G83 Peck Drilling Problem
« on: October 18, 2009, 06:43:19 AM »
What is wrong when you try the G83?
Also the min peck bug as you call it is not a bug, it is just that the increments in the macro were such that if someone used abnormally small pecks over a long distance then the macro would run out of repeatss before the depth requested was reached. It is an easy fix to adjust the macro.
Hood
Also the min peck bug as you call it is not a bug, it is just that the increments in the macro were such that if someone used abnormally small pecks over a long distance then the macro would run out of repeatss before the depth requested was reached. It is an easy fix to adjust the macro.
Hood