7321
General Mach Discussion / Re: A couple setup problems - 3 axis engraver
« on: September 30, 2012, 04:51:27 PM »
What happens when you home is Mach sets machine coordinates. The user rarely uses or cares what machine coords are as they are really for Mach to know where it is. Normally what you do once homed is jog to where you want your parts zero position to be then zero the axis DROs. By doing that you have just set up a work offset.
There is more to it than that but that is the basic setup.
Hood
There is more to it than that but that is the basic setup.
Hood