15411
General Mach Discussion / Re: Mach 3, wierd infinite feed rate problem
« on: June 27, 2010, 05:56:50 PM »
I seem to remember an issue a while back with something similar to the move you are doing. It was Ray (HimyKabibble)that found it and it only happened if your Z axis was significantly slower than your other axis.
If I recall the acceleration of the Z was ignored and Mach attempted to move the axis with the rates of the faster X and Y.
Is that the case with your Z?
Hood
If I recall the acceleration of the Z was ignored and Mach attempted to move the axis with the rates of the faster X and Y.
Is that the case with your Z?
Hood