4861
General Mach Discussion / Re: Can't get 2.2KW spindle to work
« on: June 05, 2013, 10:26:29 AM »
The big problem is the manual is , well to be frank, crap. I mentioned a few posts ago that there is a power connector to the right of the analogue out, the manual mentions it but is not clear what it is for. It says its for an external power supply to enable the VFD, I presume it is meant to power the analogue output signal but......
I think you should ask Arturo what gets connected to that power input.
Hood
I think you should ask Arturo what gets connected to that power input.
Hood