20821
General Mach Discussion / Re: Converting a DSP Controller system to Mach 3
« on: December 20, 2008, 08:30:25 AM »
Depending on what voltage is used in your control would depend on the best way to proceed. The limits and home switches seem to be 24V which is good for noise imunity and is what I have but if the 24V carries on out of that board then you would need to convert it to 5V before you hooked it up to your computer. I am busy working out how I am going to fit the spindle motor to my lathe at the moment but I will have a better look through the docs later on and see if I can gather any clues, in the mean time if you know what voltage comes out of the connector let us know.
Hood
Hood