1. On the attached Table Display photo although my drawing is at 0 of X&Y, the green / red X&Y is at the left of my drawing. Does it matter?
No thats as it should be
2. On the program run screen and under the DRO’s there are the buttons “Machine Coords” and “Soft Limits”. Does it matter which button is highlighted?
Normally you would not have Machine coords enabled as most of the time you dont need to see them. Softlimits will depend whether you have any set up, if you do then its best to always have them enabled.
3. I get the message “No shuttle detected of type Selected” How can I correct this?
Go to the plugins folder and delete the shuttle plugin.
4. The button “Spindle CW F5” on the Spindle Speed screen is blinking. The values bellow this button are
RPM=0
S – ov = 8000
Spindle Speed 8000
What is wrong here?
Not sure about that, could it be you have pressed the screen button for the spindle or have a brain or macro or even code calling the spindle start?
Hood