3531
General Mach Discussion / Re: z axis gaining height with vcarve toolpath's only
« on: December 30, 2013, 04:47:51 PM »
Was the line in driver test smooth or did it have spikes?
Your xml looks fine but your steps per unit seem small, what setup do you have, ie any microstepping, what pitch screws? any reduction between motor and screw?
You could try Sherline mode.
Hood
Your xml looks fine but your steps per unit seem small, what setup do you have, ie any microstepping, what pitch screws? any reduction between motor and screw?
You could try Sherline mode.
Hood