10221
General Mach Discussion / Re: Do not allow any movement until servo drives ready
« on: November 13, 2011, 02:17:53 PM »
I have fault signals from my drives which I tie together (with other conditions) in the ladder of my PLC which then inputs that as an E-Stop signal to Mach. So unless my drives are out of fault condition then I can not get Mach out of reset. It also means if any of my drives (axis or spindle) fault then so does Mach.
I am not sure how your drives work however as you mention reset boots them? I power my drives via my E-Stop button, it pulls in contactor (amongst other things) which power the drives.
Hood
I am not sure how your drives work however as you mention reset boots them? I power my drives via my E-Stop button, it pulls in contactor (amongst other things) which power the drives.
Hood