16131
General Mach Discussion / Re: Spindle wont start on first run
« on: March 17, 2010, 06:21:40 PM »
I had a look through the xml and only thing I see is you have an output set to pin 18, pin 18 is a gnd pin so you cant use that. I dont think it will mess with things but you never know.
I dont have a computer here set up with a PP so will have to wait until tomorrow to grab the PP I have at the workshop for testing, if you dont hear from me by this time tomorrow shout again as I will likely have forgotten
Hood
I dont have a computer here set up with a PP so will have to wait until tomorrow to grab the PP I have at the workshop for testing, if you dont hear from me by this time tomorrow shout again as I will likely have forgotten
Hood