23561
General Mach Discussion / Re: 3-Axis ProboStep Stepper Motor Driver Kit
« on: March 09, 2008, 06:38:07 AM »
Your best bet would be to ask ProboStep guy himself.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
is there anywhere on your port hardware properties dialog that you can set it into SPP, BPP or hell even EPP mode? I seem to remember reading somewhere that ECPs can be a bit troublesome with non printer devices - if you can't disable it can you stop it setting that strobe high? - sorry grasping at straws now...