431
General Mach Discussion / Re: Mach3 Turn Wizard error - *** Roughing Cut = 0 *****
« on: August 22, 2016, 06:31:36 PM »
Not sure where the problem could be then as I used the wizards you attached and could enter values in no problem.
The code produced does seem to have issues with the arcs but that is likely because I have tools set as rear toolpost in the tool table.
Unlikely to be your keyboard if you can enter values in to the other DROs, so afraid I do not really know what to suggest.
I have altered a couple of the wizards for my Lathe but not sure if they would work for your setup, likely I reversed the arcs, I also have set Z clearances and tool change DROs etc so it looks a lot more complex.
I have attached them if you want to give it a try, just unzip into the addons folder and when you load the wizards you should see Turning, which is yours and Turning1 which is mine.
Hood
The code produced does seem to have issues with the arcs but that is likely because I have tools set as rear toolpost in the tool table.
Unlikely to be your keyboard if you can enter values in to the other DROs, so afraid I do not really know what to suggest.
I have altered a couple of the wizards for my Lathe but not sure if they would work for your setup, likely I reversed the arcs, I also have set Z clearances and tool change DROs etc so it looks a lot more complex.
I have attached them if you want to give it a try, just unzip into the addons folder and when you load the wizards you should see Turning, which is yours and Turning1 which is mine.
Hood